Hitachi Compute Blade 2000 User Manual page 80

I LINK LED for XFP
Lights solid green when a link is established.
Lights solid orange when a failure is detected.
J TX/RX LED for XFP
Lights solid green when a link is established or during communication.
 10 Gbps Data Center Bridging (DCB) switch module
E
A
B
C
A Location ID LED (LOCID)
Lights solid blue while the switch module is located.
B POWER LED (PWR)
Lights solid green when power is supplied.
Turns off when the power fails or no power is supplied.
C STATUS1 LED
Indicates the status of the module. Lights solid green during normal operation.
Blinks green during power-on diagnosis or software activation.
Blinks red during a warning when the temperature exceeds the threshold or a
deconfiguration occurs while the switch is working.
Lights solid red when the switch has a serious failure causing improper
performance.
D SFP interface connector 1 to 8
SFP+ modules, SFP modules (1000Base T connection), or direct attach
cables can be connected. Connect optical fiber cables to SFP+ modules.
E Uplink port diagnostics LED
Indicates a state of uplink port diagnostics.
Lights solid orange when the signal is received but not online.
Blinks orange at low speed when the port is disabled by setting Disable with a
command or performing diagnostics.
Blinks slowly when the port is disabled due to the disable setting with a
command, or under diagnosis.
Blinks orange at high speed when the port is in failure.
Turns off when the signal is not received.
F Uplink port status LED
Indicates the state of an uplink port.
F
D
29