Hitachi Compute Blade 2000 User Manual page 584

If you make changes to the setting, the new setting value is displayed. A confirmation
message appears. Enter Y, and press Enter, and the partition setting becomes
effective. To cancel the setting, enter N and press Enter, or just press Enter after the
confirmation message appears.
(S,P,R,C,[Q]) : R
Select partition (0-7,[Q=Quit]) : 2
N+M cold standby : Enable
(0=Disable,1=Enable,[Unchange]) : 0
Method : Inline
(0=PXE,1=Inline,[Unchange]) : 1
type : Additional
(0=Original,1=Additional,[Unchange]) : 0
MAC type : Additional
(0=Original,1=Additional,[Unchange]) : 0
-- Pre-configure setting --
P N+M cold standby Method
- ---------------- ------ ---------- ----------
0 Disable PXE
1 Disable Inline Additional Additional
2 Disable Inline Original
3 Enable Inline Additional Additional
4 Enable Inline Additional Additional
5 Disable Inline Additional Original
6 Disable Inline Additional Original
7 Disable Inline Additional Original
Confirm? (Y,[N]) : Y
- Writing setting was completed.
Hit enter key.
Applicable type of WWN depends on whether N+M cold

standby is enabled or disabled, and what type of Smart
Configure method is used.
Item Description of item
Enable Inline
PXE
Disable Inline
PXE
Applicable type of MAC depends on what type of Smart

Configure method is used.
Description of item
Inline
PXE
type MAC type
Original Original
Original
Value
Additional
additional
original
original
Value
Additional A type of MAC can be selected
with In-line method.
original
original Default Physical MAC is used
with PXE method.
533
Description of value
When N+M cold standby is
enabled, the Optional Physical
WWN is used regardless of Smart
Configure method.
Can select a type of WWN with
the inline method.
The Default Physical WWN is
used with the PXE method
Description of value