Hitachi Compute Blade 2000 User Manual page 583

Displayed
order
1 Synchronization setting with chassis power operation.
2 Action setting when the power is restored.
3 Wait time to power on the partition when the power is restored.
If you enter a wait time to power-on the partition during power recovery, the new wait
time is displayed. A confirmation message appears. Enter Y and press Enter, and the
partition setting becomes effective. To cancel the setting, enter N and press Enter or
just press Enter after the confirmation message appears.
Select partition (0-7,[Q=Quit]) : 0
Chassis power sync : Sync
(0=Sync,1=Ignore,[Unchange]) :
AC recovery : Stay off
(0=Stay off,1=Power on,2=Last state,[Unchange]) :
Recovery wait(min) : 0
(0-60,[Unchange]) :
-- Power setting --
P Chassis power sync AC recovery Recovery wait(min)
- ------------------ ----------- ------------------
0 Sync
1 Sync
2 Sync
3 Sync
4 Sync
5 Sync
6 ----------------
7 Sync
Confirm? (Y,[N]) : Y
- Writing setting was completed.
Hit enter key.
If you enter R in the PR command menu and press Enter, you can set the Smart
Configure. You are required to select a partition at the prompt. Enter a partition number.
Press Enter, or input the setting value and press Enter to go to the next setting.
Displayed
order
1 Setting to enable or disable the N+M cold standby
2 Setting for Smart Configure method
3 Setting a type of WWN used for Smart Configure
4 Setting a type of MAC
Stay off
Stay off
Stay off
Stay off
Stay off
Stay off
--------- ----------------
Stay off
532
Item
0
0
0
0
0
0
0
Item