Hitachi Compute Blade 2000 User Manual page 545

Select power supply module (0-3,A=All,[Q=Quit]) : 0 (Enter)
AC recovery : Enable
(0=Disable,1=Enable,[Unchange]) : 0 (Enter)
-- Power supply AC recovery setting --
PS AC recovery
-- -------
0 Disable
1 Enable
2 Enable
3 Enable
Confirm? (Y,[N]) : Y (Enter)
- Writing setting was completed.
Hit enter key. (Enter)
 MMC command
You can set a management module and display the status. Enter MMC at the prompt,
and press Enter.
5713RF0 NNNNN(0)SVP> MMC
<< MMC - Management module control. >>
-- Management module status --
M Behavior Power Condition LID lamp
- -------- ----- ------------- --------
0 Active On
1 Standby On
-- Management module control menu --
P. Power control.
L. LID lamp control.
Q. Quit.
(P,L,[Q]) :
Select a menu item you require from the following list, and execute it.
Menu
P. Power control.
L. LID lamp control.
Q. Quit
(Enter)
Normal Off
Normal Off
Executes the power operation of the management module.
Executes the identification LED of the management
module.
Quits the MMC command.
494
Description