Hitachi Compute Blade 2000 User Manual page 743

# Item
1 Part/Model
Number
2 Serial Number
Items of information on the I/O slot expansion unit connected to the I/O adapter are
described in the table below (per I/O adapter connected to the I/O slot expansion
unit).
# Item
1 I/O adapter for I/O
slot expansion
units
2 Port number
World Wide Port
3
Name
4 World Wide Node
Name
When a fibre channel adapter has two ports,

information on four ports is displayed. In this case,
WWNs unique to the fibre channel adapter are
displayed in port0 and port1, and a value consisting of
all 0, zero, is displayed in port2 and port3 as WWN.
For 10 Gb CNA adapter or 10 Gb CNA board, the

following values are shown.
WWN for port 0 is the WWN value for port 0 of the controller 0.

WWN for port 1 is the WWN value for port 1 of the controller 0.

WWN for port 2 is the WWN value for port 0 of the controller 1.

WWN for port 3 is the WWN value for port 1 of the controller 1.

WWN is shown only when CNA Personality setting is
FCoE.
When a single CNA controller is installed, WWN values
for port 2 and port 3 are shown as all 0, zero.
For Emulex 8 Gb 2-port fibre channel mezzanine card,

current WWN may be shown in the Default Physical
WWN field.
Applicable EFI firmware versions with each server blade model are as

follows:
- All EFI firmware versions with standard server blade X55A1 and X55A2
models
- All EFI firmware versions with high-performance server blade X57A1
model
- EFI version 07-29/08-29 or earlier with high-performance server blade
X57A2 model
To find the Default Physical WWN for Emulex 8 GB 2-port fibre channel

mezzanine card, perform the following steps:
1. Shut down the OS and power off the server blade.
2. Power on the server blade and boot the OS.
3. Check the Default Physical WWN without rebooting the OS.
Description
Part/Model number of the I/O slot expansion unit
Serial number of the I/O slot expansion unit
Description
Slot numbers of the I/O adapter on the I/O slot expansion
unit.
-
The World Wide Name (WWN)
An asterisk (*) is appended if an Optional Physical WWN
has been changed from its initial value.
WWN
An asterisk (*) is appended if an Optional Physical WWN
has been changed from its initial value.
692
Edit
-
-
Edit
-
-
-
-