Hitachi Compute Blade 2000 User Manual page 782

Server chassis
# Item
1 Power capping
2 Maximum power
cap
3 Minimum value of
maximum power
cap
Partition
# Item
1 Partition
Current power cap
2
status
3 Power cap setting
4 Maximum power
cap
5 Minimum value of
maximum power
cap
6 Current power
capping mode
7 Control mode
setting
8 Exception
handling
The power control function.
# Item
Power supply
1
module
redundancy
2
Power supply
optimization
3
Power off order of
partition
Description
Indicates that a limit is imposed on the power
consumption of the server chassis.
Set as: Enabled or Disabled
The maximum power consumption when chassis power
consumption control is enabled.
Set as: 0 to 65535 (in watts)
If you specify a value lower than the minimum specifiable
value, the minimum specifiable value is used instead.
The minimum value that can be specified as the limit
value.
Set as: 0 to 65535 (in watts)
Description
The partition number of a partition.
The current status of the power capping feature.
Set as: Enabled or Disabled
The power capping setting.
Set as: Enabled or Disabled
The level at which power capping is implemented.
Set as: 0 to 65535 (in watts).
If you specify a value lower than the minimum power cap,
the minimum power cap is used instead.
The minimum value specifiable as the power cap.
Set as: 0 to 65535 (in watts).
The current control mode status.
Set as: Static or Dynamic
The control mode setting.
Set as: Static or Dynamic
Static may not be enabled depending on a type of the
server blade.
The processing performed when an exception occurs
during dynamic control.
Set as: Warning only or Warn & Set Frequency.
Description
The redundancy setting of the power supply module.
Set as: None, N+1, or N+N
The optimized power control setting.
Set as: Enabled or Disabled
The order in which partitions are turned off in the event
that power supply module redundancy can no longer be
maintained.
731
Edit
Yes
Yes
Edit
Yes
Yes
Yes
Yes
Edit
Yes
Yes
Yes