Hitachi Compute Blade 2000 User Manual page 580

Select a menu you require from the following list, and execute it.
Menu
S. Show partition status.
P. Edit power setting.
R. Edit pre-configure setting.
Edit physical partition
C.
configuration.
Q. Quit
Power settings for partitions are described in the table below.
Item Description of item
P Partition number
Chassis Power synchronization
power setting between
sync chassis and partition
(This item is not supported.
To be synchronized with
the power operation for the
chassis regardless of this
setting value.)
AC Action setting when the
recovery power is restored
Recovery Wait time to turn on the
wait (min) partition when the
power is restored.
Partition Smart Configure setting are described in the table below,
Item Description of item
P Partition number
N+M cold Enable/Disable N+M
standby cold standby
Method Operational value for
(Current) Smart Configure
method
Description
Displays the partition status.
Edits the power setting of .partitions.
Edit the Smart Configure setting of partitions.
Edits the Smart Configure of partitions.
Quits the PR command.
Value
0 to 7 -
Synchronize
Ignore Not synchronized.
------- Ineffective partition
Stay off Remain "OFF" when the power is
restored.
Power on Turns on power when the power is
restored.
Last state If the power is on before the failure,
the power turns on when the power
is restored.
------- Ineffective partition
0 to 60 minute(s)
------- Ineffective partition
Value
0 to 7 -
Enable -
Disable -
------- Ineffective partition
ERROR Fails to obtain values.
PXE Performs Smart Configure with
PXE method.
inline Performs Smart Configure with
inline method.
------- When an ineffective partition is
initialized, no server blade is
installed, the firmware
configuration is improper, or the
system is busy.
ERROR Fails to obtain values.
529
Description of value
Description of value