Megaraid Webbios - Hitachi Compute Blade 2000 User Manual

MegaRAID WebBIOS

The system equipment with serial attached SCSI (SAS) internal RAID board: GVX-
CA2SRD2X1/GV-CA2SRD2X1-Y can set a disk array using the MegaRAID WebBIOS utility.
Under normal operation, you do not need to change the settings.
Setting is required only if you need to change the system configuration, for example, when
you have changed hard disks. It is not necessary for the system configuration to be changed
for usual operation.
Make sure to operate MegaRAID WebBIOS in accordance with descriptions in this manual,
because it might not work properly. Do not execute the operation other than described in this
manual.
!
Note
When using a mouse in MegaRAID WebBIOS operations,
change the setting for the mouse of the remote console to
Relative mode.
Change the mode to Relative mode referring to
mode settings for the remote console
MegaRAID WebBIOS.
!
When using the boot from an external storage, disable the
Note
boot from MegaRAID WebBIOS.
Referring to BIOS settings for SAS internal RAID
change the controller BIOS setting to Disabled.
When booting from an external storage, disable

the boot from MegaRAID WebBIOS.
See the following to change the Controller BIOS
to Disabled:
With MegaRAID SAS 1078, see
SAS internal RAID
With MegaRAID SAS 2108, see
SAS internal RAID board.
With MegaRAID SAS 2208, see
SAS internal RAID
Connect a mouse to the remote console before

starting MegaRAID.
Mouse
before starting
board,
BIOS settings for
board.
BIOS settings for
BIOS settings for
.
175