3
Check the host bus adapter (HBA) BIOS settings.
Check the following when an HBA port is connected to an LU that contains a
dump partition..
HBA BIOS is Enabled.
See "Procedure to set a HBA-BIOS to Enable" in the Hitachi Gigagbit Fibre
Channel Adapter User's Guide (BIOS/EFI Edition) for detailed procedures .
The LU with a dump partition is registered in Boot Priority.
See "Procedure to set a Boot Priority" or "Procedure to set a Boot Priority
manually" in the Hitachi Gigagbit Fibre Channel Adapter User's Guide
(BIOS/EFI Edition) for detailed procedures.
4
Enable the hardware memory dump.
Enter the EFI setup menu and select hardware memory dump Settings to
display the setting screen.
Select hardware memory dump and then select Enabled in the subscreen.
170