Hitachi Compute Blade 2000 User Manual page 982

 LFT command
You can set redundancy to LAN ports. Type LFT at the prompt and press Enter.
5713RF0 NNNNN(0)IOEU> LFT
<< LFT - Link Fault Tolerance setting. >>
-- Link Fault Tolerance setting --
Ext port I/O module
-------- ----------------- ------- ------- -----
MGMT Active
MNT Active
-- Link Fault Tolerance setting menu --
G. Edit management port setting.
Q. Quit.
(G,[Q]) :
Select a menu item from the following list to execute it.
Menu
G. Edit management port
setting
Q. Quit
Items on the screen are described in the table below.
Menu
Ext port
I/O module
LFT
Down(s)
Up(s)
(Enter)
LFT Down(s) Up(s)
Enable 3 180
Enable 3 180
Edit redundancy setting on MGMT port of the I/O module.
Quits the LFT command.
External output port
MGMT: MGMT port; MNT: MAINT port
I/O module with open ports
Active: unit management master
Standby: non-unit management master
Redundancy status of the management LAN port:
Enable or Disable
How many seconds takes to ascertain that the external
output port is linkdown: 1 to 3600 seconds can be set.
How many seconds takes to ascertain that the external
output port is linkup: 1 to 3600 seconds can be set.
931
Description
Description