Cable Connection To The I/O Slot Expansion Unit - Hitachi Compute Blade 2000 User Manual

Cable connection to the I/O slot expansion
unit
Connection with LAN cable
!
Failure occurs in an I/O slot expansion unit connected to a
N
Note
network, if a device with the same IP address as that of the
o
I/O slot expansion unit exists on the network. Configure the
t
network settings of the I/O slot expansion unit before e
connecting the unit to the network.
Both straight cable or cross cable are available for the LAN port for the system console.
10/100 Mbps is automatically selected as the communication rate.
Connect the MGMT0 port of the I/O module in the back of the I/O slot expansion unit to
your system console terminal using a LAN cable. Since two I/O modules are installed,
connect to the I/O module with the status LED (STS) that lights solid orange. Prepare a
LAN cable to connect to the terminal.
LAN cable
872
STS
System console
terminal