Hitachi Compute Blade 2000 User Manual page 450

41 Invalid SAS topology detected. Check your cable
configurations, repair the problem, and restart
your system.
42 Invalid SAS Address present in SBR. Contact
your system support. Press any key to continue
with the default SAS address.
43 Invalid SAS Address present in MFC data.
Program the valid SAS Address, and restart your
system.
44 Invalid memory configuration detected. Contact
your system support. System has halted.
45 Entering the configuration utility in this state will
result in drive configuration changes. Press Y to
continue loading the configuration utility or power
off your system and check your cables to ensure
that all the disks are present, and then restart.
46 External Enclosure does not support in
controller's Direct mapping mode. Contact your
system support. System has halted due to
unsupported configuration.
47 Expander Detected in controller with Direct
mapping mode. Reconfiguring automatically to
persistent mapping mode. Automatic reboot
would happen in 10 seconds.
48 The controller's I/O processor has a fault that can
potentially cause data corruption. Your controller
needs replacement. Contact your system support.
Press Y to acknowledge.
Number of disks exceeded the maximum
49
supported count of X disks. Remove the extra
drives and reboot the system to avoid losing data
Press Y to continue with extra drives.
50 Number of devices exceeded the maximum limit
of devices per quad. Remove the extra drives and
reboot the system to avoid losing data. System
has halted due to unsupported configuration.
51 Drive security is enabled on this controller and a
pass phrase is required. Please enter the pass
phrase.
52 Invalid pass phrase. Please enter the pass
phrase.
53 There was a drive security key error. All secure
drives will be marked as foreign. Press any key to
continue, or C to load the configuration utility.
54 Invalid pass phrase. If you continue, there will be
a drive security key error and all secure
configurations will be marked as foreign. Reboot
the machine to retry the pass phrase or press any
key to continue.
Message
399
Description
When this message is displayed, contact your
reseller or call maintenance personnel.
When this message is displayed, contact your
reseller or call maintenance personnel.
When this message is displayed, contact your
reseller or call maintenance personnel.
Hard disk configuration information has been
changed. When this message is displayed, contact
your reseller or call maintenance personnel.
Incorrect information was detected from the
enclosure. When this message is displayed,
contact your reseller or call maintenance
personnel.
An unsupported device (expander) is detected.
When this message is displayed, contact your
reseller or call maintenance personnel.
The processor of the controller is faulty. When this
message is displayed, contact your reseller or call
maintenance personnel.
Improper hard disks are detected. When this
message is displayed, contact your reseller or call
maintenance personnel.
Hard disk security functions are not supported.
When this message is displayed, contact your
reseller or call maintenance personnel.