Hitachi Compute Blade 2000 User Manual page 601

(A,N,[Q]) : N (Enter)
Select partition (0-7,[Q=Quit]) : 0 (Enter)
IP address : 192.168. 1. 1
([Unchange]) : 192.168.1.10 (Enter)
Subnetmask : 255.255.254. 0
([Unchange]) : (Enter)
Default gateway : 0. 0. 0. 0
([Unchange]) : (Enter)
-- Partition network setting --
P IP address Subnetmask
- --------------- --------------- --------------- --------
0 192.168. 1. 10 255.255.254. 0
1 192.168. 1. 2 255.255.254. 0
2 192.168. 1. 3 255.255.254. 0
3 192.168. 1. 4 255.255.254. 0
4 192.168. 1. 5 255.255.254. 0
5 192.168. 1. 6 255.255.254. 0
6 192.168. 1. 7 255.255.254. 0
7 192.168. 1. 8 255.255.254. 0
WARNING : Session may be disconnected when setting saved.
Confirm? (Y,[N]) : Y (Enter)
- <Partition0> Writing setting was completed.
Hit enter key. (Enter)
If you enter SW in the LC command menu and press Enter, the network setting of the
switch module is displayed.
(C,M,P,SW,V,[Q]) : SW
-- Switch module network setting --
SW Ext IP address
Synchronize
-- ---- ---------------- --------------- --------------- -------- ----------
-
0 Ext 0. 0. 0.
1 Int --------------
2 Int --------------
3 Int --------------
4 Int --------------
5 Int --------------
-- Switch module network setting menu --
A. Edit all switch module setting.
N. Edit one switch module setting.
S. Show switch module current network setting.
W. Synchronize network setting to switch module.
Q. Quit.
(A,N,S,W,[Q]) : (Enter)
Default gateway Ext port
0. 0. 0. 0
0. 0. 0. 0
0. 0. 0. 0
0. 0. 0. 0
0. 0. 0. 0
0. 0. 0. 0
0. 0. 0. 0
0. 0. 0. 0
Subnetmask Default gateway Ext port
0 0. 0. 0. 0 0.
------------- -------------
------------- -------------
------------- -------------
------------- -------------
------------- -------------
550
MGMT-0
MGMT-0
MGMT-0
MGMT-0
MGMT-0
MGMT-0
MGMT-0
MGMT-0
0. 0. 0 MGMT-0 No
------ ---------
------ ---------
------ ---------
------ ---------
------ ---------