Hitachi Compute Blade 2000 User Manual page 376

Message
Number of devices exceeded the maximum limit
of devices per quad Please remove the extra
drives and reboot system to avoid losing data.
System has halted due to unsupported
configuration.
Drive security is enabled on this controller and a
pass phrase is required. Please enter the pass
phrase.
Invalid pass phrase. Please enter the pass
phrase.
There was a drive security key error. All secure
drives will be marked as foreign.
Invalid pass phrase. If you continue, there will be
a drive security key error and all secure
configurations will be marked as foreign. Reboot
the machine to retry the pass phrase or press any
key to continue.
Unable to communicate to electronic key
management systems (EKMS). If you continue,
there will be a drive security key error and all
secure configurations will be marked as foreign.
Please check connection with the EKMS, reboot
the machine to retry the EKMS, or press any key
to continue.
Unable to Rekey security to EKMS as not able to
communicate to EKMS. If you continue, the drive
security will remain in the existing security mode.
Please check connection with the EKMS, reboot
the machine to retry the EKMS or press any key
to continue.
The native configuration is no longer supported
by the current controller settings. Please ensure
that correct controller or iButton is being used. If
you continue, the configuration will be marked
foreign and part of it may be imported if possible.
Press any key to continue.
The battery is currently discharged or
disconnected. Verify the connection and allow 30
minutes for charging. If the battery is properly
connected and it has not returned to operational
state after 30 minutes of charging, then contact
technical support for additional assistance.
The battery is currently discharged or
disconnected. VDs configured in write-back mode
will run in write through mode to protect your data
and will return to write-back policy when the
battery is operational. If VDs have not returned to
write-back mode after 30 minutes of charging,
then contact technical support for additional
assistance. The following VDs are affected: X2
Press any key to continue.
Description
Hard disk security functions are not supported.
When this message is displayed, contact your
reseller or call maintenance personnel.
Hard disk security functions are not supported.
When this message is displayed, contact your
reseller or call maintenance personnel.
When this message is displayed, contact your
reseller or call maintenance personnel.
Battery backup unit information is incorrect. When
this message is displayed, contact your reseller or
call maintenance personnel.
325