Hitachi Compute Blade 2000 User Manual page 862

Backing up the entire switch module
1 Backup using the ftp server (Server address: 192.168.0.128/user name: staff).
> enable
<= Press [Enter].
# backup ftp ftpserver MCBackup.dat
# ./backup ftp 192.168.0.128 MCBackup.dat
Backup information to FTP (192.168.0.128) MCBackup.dat.
Input username: staff
Input password:
.
ftp transfer start.
ftp transfer succeeded.
2
Backup using the MC (Stored into the MC).
> enable
<= Press [Enter].
# backup mc MCBackup.dat
Backup information to MC (MCBackup.dat).
Copy file to MC...
Backup information success!
Restoring the switch module information
1 Restore using the ftp server (Server address: 192.168.0.128/user name: staff).
> enable
<= Press [Enter].
# restore ftp 192.168.0.128 MCBackup.dat no-software
Restore information from FTP (192.168.0.128) MCBackup.dat.
Input username: staff
Input password:
ftp transfer start.
Operation normal end.
ftp transfer succeeded.
restore finished.
2 Restore using the MC (Read from the MC).
> enable
<= Press [Enter].
# restore mc MCBackup.dat no-software
Restore information from MC (MCBackup.dat).
Copy file from MC...
restore finished.
You can take a backup the switch module information
including switch software by the restore command. However,
the switch software has the hardware related information,
therefore, it might not run on the new hardware. Use the no-
software option when you restore it after replacing the
hardware.
<= Press [Enter].
<= Press [Enter].
<= Press [Enter].
<= Press [Enter].
<= Enter the password and press [Enter].
811
<= Press [Enter].
<= Press [Enter].
<= Press [Enter].