Advertisement
Bit 6—Receive Interrupt Enable (RIE): Enables or disables receive data full interrupt (RXI)
request and receive error interrupt (ERI) request generation when serial receive data is transferred
from RSR to RDR and the RDRF flag in SSR is set to 1.
Bit 6
RIE
Description
0
Receive data full interrupt (RXI) request and receive error interrupt (ERI) request
disabled*
1
Receive data full interrupt (RXI) request and receive error interrupt (ERI) request
enabled
Note:* RXI and ERI interrupt request cancellation can be performed by reading 1 from the RDRF
flag, or the FER, PER, or ORER flag, then clearing the flag to 0, or clearing the RIE bit to 0.
Bit 5—Transmit Enable (TE): Enables or disables the start of serial transmission by the SCI.
Bit 5
TE
Description
0
Transmission disabled*
1
Transmission enabled*
Notes: 1. The TDRE flag in SSR is fixed at 1.
2. In this state, serial transmission is started when transmit data is written to TDR and the
TDRE flag in SSR is cleared to 0.
SMR setting must be performed to decide the transfer format before setting the TE bit
to 1.
Bit 4—Receive Enable (RE): Enables or disables the start of serial reception by the SCI.
Bit 4
RE
Description
0
Reception disabled*
1
Reception enabled*
Notes: 1. Clearing the RE bit to 0 does not affect the RDRF, FER, PER, and ORER flags, which
retain their states.
2. Serial reception is started in this state when a start bit is detected in asynchronous
mode or serial clock input is detected in clocked synchronous mode.
SMR setting must be performed to decide the transfer format before setting the RE bit
to 1.
1
2
1
2
(Initial value)
(Initial value)
(Initial value)
595
Advertisement
