Mitsubishi Electric 700 Series Training Manual page 104

3. Setup Screen
Display item
(4) Guide drawing
(5) Tool compensation data
Menus
Menu
This writes the value displayed in "Mea value" as the tool
compensation amount.
Offset
The wear amount is cleared to "0" for the tool compensation type II.
write
The tool compensation amount cannot be written in when the menu
Offset No. or Surface hight
When the compensation No. is set and the
Offset
the tool compensation data with that number at its head appears.
No.
The cursor moves to the length dimension data of the top line of that
data.
This sets the reference surface height data. (The cursor moves to the
reference surface height.)
Surface
hight
When the data is set in the input area and the
pressed, the reference surface height is set.
This changes the mode to the tool length measurement mode.
This mode is enabled when turning ON the power.
T-leng
measure
(The cursor moves to the length dimension position for tool
compensation type II.)
This changes the mode to the tool radius measurement mode.
(The tool measurement type is valid only for tool length measurement
T-rad.
II.)
measure
(The cursor moves to the radius dimension position for tool
compensation type II.)
This displays the measurement image. The contents of the guide drawing will differ
depending on the tool measurement type.
Tool length measurement I guide drawing Tool length measurement II guide drawing
This displays the tool compensation data. Depending on the tool compensation type
(I/II), the display details of the displayed tool compensation data will differ.
Details
is highlighted.
INPUT key is pressed,
96
3.3 Tool Measurement
Details
Type
INPUT key is
Reference
C
A 3.2.1 Setting the Tool
Compensation Data
A
B Carrying Out Tool
Length Measurement
B Carrying Out Tool
Radius Measurement