Tool Compensation Amount - Mitsubishi Electric 700 Series Training Manual

2. Monitor Screens

2.9 Tool Compensation Amount

The tool compensation data can be set and displayed.
The tool compensation data screen configuration differs according to the tool compensation type.
The number of tool compensation sets to be set or shown differs according to the option.
Refer to section "3.2 Tool Compensation Amount" for details.
[Tool compensation type I (M system)]
The combined amount of the shape compensation and wear compensation are set as the compensation
data, with no distinction between shape compensation memory and wear compensation memory. (The
tool compensation data is the shape compensation amount + wear compensation amount.)
The compensation data is used commonly for the tool length compensation, tool position offset, tool
radius compensation, and three-dimensional tool radius compensation.
[Tool compensation type II (M system)]
The shape compensation amount and wear compensation amount are set separately. The shape
compensation amount is furthermore divided into length and radius dimensions.
Of the compensation data, the length dimension data is used for the tool length compensation and tool
position offset, and the radius dimension data is used for the tool radius compensation and
three-dimensional tool radius compensation.
2.9 Tool Compensation Amount
Parameter "#1037 cmdtyp" = 1
Parameter "#1037 cmdtyp" = 2
47