Mitsubishi Electric 700 Series Training Manual page 94

3. Setup Screen
[Tool compensation type III (L system) ] : Parameter "#1037 cmdtyp" = 3
The wear data, tool length data and tool nose data are set separately. These are changed with the
sub-menu.
(a) Wear data
Set the tool nose wear amount for each tool used. When the tool compensation No. is designated by the
tool command (T command), compensation is carried out matching the tool length data and tool nose
data.
(b) Tool Length Data
Set the tool length in respect to the program basic position of each tool used.
When the tool compensation No. is designated by the tool command (T command), compensation is
carried out matching the wear data and the tool nose data.
3.2 Tool Compensation Amount
86
(1)
(1)