Program Editing - Mitsubishi Electric 700 Series Training Manual

4. Edit Screens

4.2 Program Editing

This is used to edit (add, erase, change) the machining programs in the NC memory, HD, memory card (front
IC card), DS(compact flash) or FLD, and to create new programs.
This function is used for three types of program: machining program, MDI program and fixed cycle program.
Press the main menu Edit key to display the program found when performing an operation search (MDI
program in MDI mode).
The contents of the left area depends on the display type:
Check display type
Multi-program display type
G-code guidance display type
There are two types of editing available: regular editing and mass-editing.
With mass-editing, up to a 2GB-sized file can be edit.
The specification and restrictions are different from those with the regular editing.
Mass-editing is available only with FCU7-DA4xx/DA3xx.
Mass-editing is applied when the following conditions are satisfied.
• When the storage destination for the program to be opened is either HD, FLD, or memory card.
• When a file size is 1.0MB or larger. (When the parameter "#8910 Edit Undo" is set to "0", 2.0MB or
larger.)
:Enables to edit a program confirming the program check screen.
:Enables to edit two programs using left and right editing areas.
:Enables to edit a program referring to the G code guidance.
144
4.2 Program Editing
(1)
(3)
(2)
(4)
(5)