3. Setup Screen
3.7 Workpiece Measurement
Move the sensor attached to the spindle using manual feed or handle feed to contact the workpiece, measure
the coordinate position, and then set that measurement result for the workpiece coordinate system offset
amount.
There are three measurement patterns: surface measurement, hole measurement, width measurement, and
rotation measurement.
For the rotation measurement, the measurement result is set in the workpiece offset (rotation center) and
parameters "#8624 Coord rot centr(V)", "#8626 Coord rot vctr(H)", and "#8627 Coord rot angle".
(Note) The M system is equipped with the workpiece measurement function. A workpiece position
measurement option is required.
■ For surface measurement (As for the hole or width measurement, the guide drawing differ.)
(1)
(4)
(5)
■ For rotation measurement
(1)
(7)
(8)
(5)
(9)
3.7 Workpiece Measurement
130
(2)
(3)
(6)
(2)
(3)
(4)
(6)