Undoing Program Changes - Mitsubishi Electric 700 Series Training Manual

4. Edit Screens

4.2.15 Undoing Program Changes

This is used to return the program to the form when INPUT was last pressed to save. This operation is
valid for the operation of "Rewriting program", " Insert " , " Delete " , "Line Paste", "Line Clear", "Character String
Replace" and "Undo" functions.
Operation method (Pasting the copied data)
(1) Change to memory mode and press the
main menu Edit
(2) Move the cursor to the position to be
corrected, and input a character.
(Ex.) 135
(3) Press the
INPUT key.
(4) Press the menu
(5) Press the menu
(Note1) This function is only valid when parameter "#8910 Edit Undo" is set to "1".
(Note2) When returned to the previous status, the cursor will move to the head line.
(Note3) With the multi-program display type, returning to the previous contents is valid only in the active
area.
(Note 4) Undoing is not possible in mass-editing mode.
(Note 5) "Executing" is displayed in flickering during undoing.
key.
Undo .
Undo again.
The searched program appears from the top.
The data is replaced with input data and
The edited machining program is saved to the device and
" "
Editing disappears.
The contents of the file return to the same condition as when
the editing was started in the procedure (1).
These contents of the file are saved to the device.
The contents of the file return to the same condition as when
the file was saved in the procedure (3).
These contents of the file are saved to the device.
160
4.2 Program Editing
" "
Editing appears.