Mitsubishi Electric 700 Series Training Manual page 16

1. Operating the Setting and Display Unit
List of menu names (functions)
Screen Menu name
Monitr Search
Reserch
Edit
Trace
Check
Cnt exp
Offset
Coord
Cnt set
MST
Modal
Tree
Time
Com var
Loc var
P corr
PLC SW
G92 set
Col stp
LD MTR
Sp-stby
Setup T-ofs
T-meas
T-reg
T-life
Coord
W-meas
User
MDI
Cnt set
MST
T-list
Pallet
Edit Edit
Check
NAVI
I/O
Call a program for automatic operation.
Restart machining from a selected block.
Edit the machining program searched for operation.
Trace the T path based on the machining program being executed.
Trace the T path based on the machining program w/o running machine.
Display counters of all axes & select the type of the counters.
Set & display tool offset data.
Set & display workpiece coordinate system offset.
Set the relative position counter to an arbitrary value.
Set & display each command for S, M, T & 2nd M functions.
Display the execution modal value of the machining program.
Display program/MDI interrupt/user macro call in nesting structure.
Set & display integrating time (date, time, power ON time, etc.).
Set & display the details of common variables.
Specify a nesting level of subprogram & display local variables.
Correct & change the next command by block stop during auto-/MDI op.
Switch ON/OFF each NC ops. control signal allocated by ladder program.
Perform origin set & origin cancel.
Register arbitrary collation & stop position set as single block stop.
Spindle load and Z axis load, etc. can be displayed in meter.
The spindle tool No. and the standby tool No. can be displayed.
Set & display tool offset data.
Measure T length & radius manually & set them as tool offset amounts.
Register T No. according to the magazine pot, spindle & wait position.
Scale workpiece to figure face/hole ctr/wid ctr & set as coord ofs.
Set & display workpiece coordinate system offset.
Set & display user parameters.
Display & edit MDI programs set in NC memory.
Edit (add/delete/change) programs in NC memory & create new ones.
Set the relative position counter to an arbitrary value.
Set & display each command for S, M, T & 2nd M functions.
Reference & display T-codelist.
The machining program is registered into the pallet of APC.
Edit (add/delete/change) programs in NC memory & create new ones.
Trace the T path based on the machining program w/o running machine.
Create the part program simply.
Input/Output machining programs betw. NC memory & external I/O device.
Outline
8
1.3 Menu List