2. Monitor Screens
2.10 Workpiece Coordinate System Compensation
The coordinate system offset controlled by the NC can be set and displayed.
48 or 96 sets of coordinate system offset sets can be added according to the option.
Refer to "3.6 Workpiece Coordinate System Offset" for details.
(Note) The G92/G52 coordinate system offset cannot be set.
CAUTION
If the tool offset amount or workpiece coordinate system offset amount is changed during
automatic operation (including during single block stop), the changes will be valid from the
command in the next block or after several subsequent blocks.
2.10 Workpiece Coordinate System Compensation
50