Program Check (3D) [700 Series Only] - Mitsubishi Electric 700 Series Training Manual

4. Edit Screens
Menus
Menu
This performs an operation search and a check search.
Operate
Select a program to be checked from the program file list displayed in
search
the pop-up window.
This checks a program continuously.
Check
continu
This checks a program per block.
Check
step
This resets a program check.
Check
reset
This initializes the workpiece shape. Displays the pre-machining
Work workpiece shape set at the " Work set " window (workpiece shape
init
setting).
At this time, the cross-section status is cancelled.
This enlarges/reduces the displayed workpiece shape.
Zoom
This moves the displayed workpiece shape.
Move
This switches the normal display mode and the full-screen display
All
mode.
display
This rotates the displayed workpiece shape.
Rotate
The scale is automatically set so that the pre-machining workpiece
Auto
shape set at the " Work set " window (workpiece shape setting) takes
scale
up approximately 90% of the drawing area.
This changes the program check (2D) display.
2D
This menu cannot be selected while the check is performed or
check
interrupted.
This enables or disables the interference check.
Colli
When the interference check is enabled, if the tool and workpiece
check
contact each other when performing rapid traverse (G0) movement,
the contact location is drawn in a color highlighting the interference.
This sets the workpiece shape used at the solid display.
Work
setting
This sets the tool shape used at the solid display.
Tool
setting
(Note 1) When the graphic trace mode is entered and automatic operation is running, the menu
Operate search , Check continu , Check step , Check reset cannot be selected and
the 3D solid program check cannot be performed.
Only the 3D solid program check can be performed unless the automatic operation is running.
(Note 2) The menu 2D check , Operate search , Work setting , Tool setting cannot be selected
while the check is performed or interrupted.
Details
177
4.4 Program Check (3D)
Type Reference
C 4.4.1 Checking
Continuously
B
B 4.4.2 Checking One
Block at a Time
C 4.4.3 Canceling the
Program Check
C
C 4.4.4 Enlarging and
Reducing the Workpiece
Shape
C 4.4.5 Moving the
Workpiece Shape
C
C 4.4.6 Rotating the
Workpiece Shape
C
C 4.3 Program Check (2D)
B 4.4.7 Performing an
Interference Check
C 4.4.9 Setting the
Workpiece Shape
C 4.4.10 Setting the Tool
Shape