Mitsubishi Electric 700 Series Training Manual page 96

3. Setup Screen
Display items
Display item
(1) Display area
(continued on next page)
Displays the tool compensation data. The displayed cursor can be moved and data
set.
Data that cannot be displayed in the display area can be displayed using the keys
below.
↑ , ↓ : Scroll one line at a time.
, : Change the display contents one page at a time.
Compensation number : This is the compensation data number.
Compensation data : The display items differ depending on the tool compensation
Type I : Compensation data
Type II : Length dimension, length wear, radius dimension, radius wear
Type III : (Wear, tool length data) No. 1 axis, No. 2 axis, additional axes
(Tool nose data)
The standard settings and display ranges are as follows.
Type Settings
Type I Compensation
data
Type II Length
dimension
Length wear
Radius
dimension
Radius wear
Type III Wear data
Tool length
data
Tool nose R
(Note 4)
R wear
(Note 4)
(Note 6)
Tool nose
point P
(Note 5)
(Note 1) The display range is when the minimum command unit is 1µm ("#1003 iunit"
= B, "#1041 I_inch" = 0).
(Note 2) Set whether to set the additional axis tool nose wear compensation amount
for No. 3 or No. 4 axis at parameter " #1520 Tchg34 " .
(Note 3) Displays only for the number of valid axes if only axis 1 or 2 are valid.
(Note 4) Set at the radius value if parameter " #1019 dia" is " 0 " , or at the diameter
value if this parameter value is " 1 " .
(Note 5) An absolute setting is applied even if the tool nose point is entered by
pressing the + Input
(Note 6) Depending on the setting of parameter #8010(Max. value), the
setting/display range may be different from the above.
(Note 7) Depending on the setting of parameter #8011(Max. additional value), the
setting/display range may be different from the above.
88
3.2 Tool Compensation Amount
Details
type.
Tool nose R, R wear, tool nose point R
Details
This sets the shape and wear
combined compensation amounts.
This sets the tool length compensation
amount.
This sets the tool length wear
compensation amount.
This sets the tool radius compensation
amount.
This sets the tool radius wear
compensation amount.
This sets the No. 1 axis, No. 2 axis and
additional axis tool nose wear
(Note 2) (Note 3) (Note
compensation amount.
6) (Note 7)
This sets the No. 1 axis, No. 2 axis and
additional axis tool length
(Note 2) (Note 3)
compensation amount.
This sets the tool radius (nose R).
This sets the tool radius (nose R) wear
amount.
This sets the tool nose point (number). 0 to 9
menu and entering a value.
Setting/display
range
-999.999 to
999.999
Length/Radius
dimension:
-999.999 to
999.999
Length/Radius
wear:
-99.999 to
99.999
-9999.999 to
9999.999
-999.999 to
999.999
-999.999 to
999.999
-99.999 to
99.999