Creating A New Machining Program - Mitsubishi Electric 700 Series Training Manual

4. Edit Screens

4.2.1 Creating a New Machining Program

Operation method
(1) Press the menu
Memory
(2) Select a device.
(Ex.) Menu
(3) Input the file name for the program to be
newly created and press the
key.
(Ex.) 100
(4) Edit a machining program.
(5) Press the
INPUT key.
(Note 1) An error occurs if an existing program No. is set.
(Note 2) The texts in parentheses ( ) at the top block of the program is the comment.
(Note 3) The existing file cannot be set.
(Note 4) The characters that can be used for the file name and directory path are 1-byte number, 1-byte
capital alphabetical letters, and 1-byte symbols recognized by the system.
Note that the following characters cannot be used.
|, /, :, "," (comma), *, ?, ", <, >, a to z (small letters)
In addition, the following cases cannot be treated as the file name.
• When the extension is such as "$$$", "$$0", "$$1", "$$2", "$$3", "$$4", "$$5", "$$6", "$$7",
"$$8", "$$9".
• When the file name is 1-byte character "0" (zero).
(Note 5) Creation of a program is not possible for a program with 33 or more file name characters.
Open (New) .
Memory
HD
card
Memory
INPUT
INPUT
The following menu appears.
The list appears as a pop-up window.
DS FLD
The selected device name and directory (Memory:
/Program) appear in the Device name, Directory display
column.
For the devices other than memory, root directory is
selected.
If a program can be newly created, a program containing
only EOR is created.
The list display is closed.
"
Refer to 4.2.6 Edit Operations
The created machining program is saved to the device.
147
4.2 Program Editing
List Sort
Close
update change
"
and later.