Inputting A Machining Program; Creating And Editing A Machining Program - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
3 Inputting a Machining Program and Defining Variables
3Inputting a Machining Program and Defining Variables
This chapter explains creating and editing the machining program. Generally, operations are performed on the edit (Edit)
screen.
Refer to "Programming Manual" for details on G code programming.

3.1 Inputting a Machining Program

When using the program created by external device, input it to NC by using program input/output function. For information
on the data input/output function, refer to "4.1 Inputting and Outputting a Program".

3.2 Creating and Editing a Machining Program

Edit
Edit
The program editing function performs add, delete and change in the NC memory.
This function is used for machining program, MDI program and fixed cycle program.
On the edit screen, editing (add, erase, change) and cursor position search can be performed.
There are 3 types of display as shown below:
Multi-program display type
G-code guidance display type
Playback display type
Selected display type is retained after screen transition.
The tab under the editing area is switched depending on the selected display type.
Some tabs may not be displayed depending on the specifications.
For details on switching the display type, refer to "3.6.1 Changing the Display".
You can edit the program on the monitor screen as well. For details, refer to "9.5 Correcting the Machining Program".
CAUTION
The program including a character of any language other than the display language is not correctly displayed. Do
not edit such a program. Any part of the program other than the comment part may also be changed if edited.
IB-1501453-C
Enables you to edit two programs using each editing area.
Enables you to edit a program referring to the G code guidance.
Enables you to edit a program trying sample machining.
50