Editing Operations; Changing The Display - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
3 Inputting a Machining Program and Defining Variables

3.6 Editing Operations

Edit
Edit
When the program is edited, the key input data is directly written into the program display area. All data is overwritten from
the cursor position. "Editing" appears on the right side of the file name display once input is started.
Press the [INPUT] key to save the program to the device and clear the "Editing" message.
The editing operations from when the file is actually opened are explained in this and the following sections.
These editing operations are common for the machining program and MDI program.
Note
(1) The initial mode (overwrite/insert) at start of editing and the [DELETE] key operation (DELETE/BackSpace) can be se-
lected with the parameters. The operation with overwrite mode and DELETE operation is explained in this manual un-
less otherwise specified.
CAUTION
If there is no value after the G command, the operation will be the "G00" operation when the program is run due to
key chattering, etc., during editing.

3.6.1 Changing the Display

Switching the active area
Switching the active area is possible only when the multi-program display type is selected.
Press the [<--> change] key to switch the active area between the left and right window.
Switching the display type
Press the menu [Displaychange] to switch the display type.
The same operation can be performed with the
The display is switched in the order of multi-program display type -> G code guidance display type -> playback display type
-> multi-program display type...
Note
(1) Press to switch in the inverse order.
(2) Some tabs may not be displayed depending on the specifications. When only the edit tab is displayed, the menu [Dis-
playchange] cannot be selected.
IB-1501453-C
key.
62