Mitsubishi Electric C80 Series Instruction Manual page 216

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Note
(1) When the part system is changed while displayed on the group unit display, the registered data is not displayed because
the screen enters the "data unregistered" state. To display the group unit of the changed part system, return to the group
list display screen and execute the group unit display again.
(2) If "Cutter compen. data format" or "T-length compen data format" is set to "0", "2" (Length/radius), or "1" (Length wear/
radius wear), the tool compensation amount to be displayed by "L compen" and "R compen" are switched as follows:
Tool compen-
sation type
L compen
I
R compen
L compen
II
R compen
L compen
III
R compen
Item Method
0
The compensation amount that is set in the designated compensation
1
number
2
0
The compensation amount that is set in the designated compensation
1
number
2
0 The compensation amount that is set in the length of the designated
compensation number
1 The compensation amount that is set in the length wear of the desig-
nated compensation number
2 The compensation amount that is set in the length of the designated
compensation number
0 The compensation amount that is set in the radius of the designated
compensation number
1 The compensation amount that is set in the radius wear of the desig-
nated compensation number
2 The compensation amount that is set in the radius of the designated
compensation number
0 The compensation amount that is set in the Z axis of tool length data of
the designated compensation number
1 The compensation amount that is set in the Z axis of wear data of the
designated compensation number
2 The compensation amount that is set in the Z axis of tool length data of
the designated compensation number
0 The compensation amount that is set in nose R of the designated com-
pensation number
1 The compensation amount that is set in the R wear of the designated
compensation number
2 The compensation amount that is set in nose R of the designated com-
pensation number
Setting/display range
191 IB-1501453-C