C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
5.2.1 Registering a Tool in the Magazine Pot
Operation method (Selecting a magazine No.)
(1)
Press the menu [Magazn 2].
Note
(1) The No. of magazines differs according to the machine specification.
Operation method (Registering the tool in the magazine pot)
(1)
Designate the pot No.
[Pot No search] 21 [INPUT]
Input the tool number.
(2)
50 [INPUT]
When the [INPUT] key is pressed without setting a
value, the tool number does not change and the cur-
sor moves to the "tool number" for the next pot num-
ber.
Note
(1) Move the cursor with
and purposes.
(2) The duplication check is executed for only the tool No. The check does not depend on the setting of "D".
(3) If parameter "#8922 T-reg-dup check" is set to "1", the operation message will not appear even when the tool No. du-
plicates.
(4) The magazine to be checked varies depending on the setting of the parameter "#8922 T-reg-dup check".
5.2.2 Setting the PLC Command
Operation method (Setting the PLC command)
(1)
Set the value after the menu [PLC command].
[PLC command] 12 [INPUT]
(2)
Press the menu [PLC command], or the
complete the setting.
Note
(1) Select the menu [PLC Command] again before pressing the [INPUT] key, then the menu highlight returns to normal,
and the PLC command setting mode becomes disable.
IB-1501453-C
key to set the "D" data. Refer to the manual issued by the MTB for details on the "D" functions
key to
124
The tool data of the set magazine No. appears.
When the duplication check is valid, the operation mes-
sage "Exists in magazine 1. Set? (Y/N)" or "Exists in
spindle/standby. Set? (Y/N)", etc. appears if the input
tool No. already exists invalid magazine, spindle/stand-
by.
The set value displays in the PLC command setting field,
and the PLC command setting mode is enabled.
The function of the command depends on the MTB
specifications.
The PLC command setting mode is released, and the
menu highlight returns to normal.