Mitsubishi Electric C80 Series Instruction Manual page 228

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Display items
Display items
(1) Measurement counter
Surface measurement
counter
Hole measurement
counter
Width measurement
counter
Rotation measurement
counter
(2) Display of measure-
ment in progress
(3) Guide graphic
(4) Sensor length and di-
ameter
(5) Coordinate system off-
set
(6) Measurement position
counter
(7) Center shift amount
(8) Coordinate rotation cen-
ter
(9) Coordinate rotation an-
gle
Displays the measurement position.
The measurement axis is compatible with parameters "#1026 base_I", "#1027
base_J", and "#1028 base_K". (Hereafter indicated as I=X, J=Y, and K=Z axes in this
manual.)
The measurement position becomes blank when setting the coordinate system offset
amount, resetting the NC, or changing the measurement mode (when the menu [Face
meas], [Hole meas], [Width meas], or [Rotate measure] is selected).
The display contents differ depending on the measurement pattern (surface measure-
ment, hole measurement, width measurement, or rotation measurement).
Displays the calculated measurement position from the skip position for each axis (X-
, Y-, Z-axes).
Displays 3 (A, B, C) measurement positions.
Displays 2 (A, B) measurement positions.
Displays 3 (A, B, C) measurement positions (X-, Y-axes).
"On mea" is displayed when the measurement switch on the machine operation board
is ON.
Refer to "Manual measurement status display" in "5.3.1 Tool Measurement (M Sys-
tem)" for details.
Displays the measurement image.
The contents of the guide drawing differ depending on the measurement pattern (sur-
face measurement, hole measurement, width measurement, or rotation measure-
ment).
Sensor length: Displays the length to the tip of the touch probe.
("#8701 Tool Length" setting value)
Sensor diameter: Displays the diameter of the ball at the tip of the touch probe.
("#8702 Tool Dia" setting value)
Displays the currently selected coordinate system offset.
Displays the measurement position for all axes.
X axis: X axis machine position + sensor radius +center compensation (Horizontal)
Y axis: Y axis machine position + sensor radius +center compensation (Vertical)
Z axis: Z axis machine position - sensor length
4th axis and over: Respective machine position
Sensor length: "#8701 Tool Length"
Sensor radius: "#8702 Tool Dia" /2
Center compensation (H): "#8703 OFFSET X"
Center compensation (V): "#8704 OFFSET Y"
Displays the shift amount of the coordinate rotation center.
Displays the coordinates that are the center during coordinate rotation.
This is the setting value of "#8623 Coord rot centr (H)" and "#8624 Coord rot centr (V)".
Displays the rotation angle during coordinate rotation. This is the setting value of
"#8627 Coord rot angle".
203
Details
IB-1501453-C