Mitsubishi Electric C80 Series Instruction Manual page 330

C80 Series Instruction Manual
9 Machining a Workpiece
Display items
(5) F modal area
(6) MSTB area and con-
stant surface speed
control (constant sur-
face speed S) area
(*1) G121 command: Machining Condition Selection I Cancel
Changes to the machining condition selection command that is selected in [Setup] - [MacCond] screen.
(*2) Displays the axis name that is set to the first and second axes in the part system for the base axis specification param-
eter "#1013 axname". (If no axis name is set to "#1013 axname", the axis name item is blank.)
(*3) When the parameter "#1281 ext17 bit1" (tool offset additional axis selection) is set to "0", the display will change as
follows by the parameter "#1520 Tchg34" (additional axis tool) setting.
#1520 Tchg34 = 0: Displays the axis name configured as the third axis in the part system by the parameter "1013 ax-
name".
#1520 Tchg34 = 1: Displays the axis name configured as the 4th axis in the part system.
(If no axis name is set to "#1013 axname", the axis name item is blank.)
When the parameter "#1281 ext17 bit1" (tool offset additional axis selection) is set to "1", the name of the axis desig-
nated by the parameter "#1027 base_J" (basic axis J) is displayed. (If the axis name designated in "#1027 base_J" is
not set to "#1013 axname", the axis name item is blank.)
In the two-axis configuration system, the third row is not displayed.
Menus
Menus
This closes the pop-up window and quits this function.
Close
Note
(1) The menu is common for the M system and L system.
This area displays the F modal value and manual feedrate.
FA: Displays the program command asynchronous feedrate modal value of the currently
executed command.
FM: Displays the manual feedrate.
FS: Displays the program command synchronous feedrate modal value of the currently
executed command.
FE: Displays the thread lead command synchronous feedrate modal value of the cur-
rently executed command.
<MSTB area>
This area displays the program command modal value for each of the currently executed
commands.
Each item displays the following information:
S command
M command
T command
2nd miscellaneous function (B) command
The number of S displays varies depending on the value of the parameter "#1039 spin-
no" (Number of spindles).
The number of M displays varies depending on the value of the parameter "#12005 Mfig"
(M count).
The number of T or B displays is set to "1" regardless of the value of the parameter
"#12009 Tfig" (T count) and "#12011 Bfig" (B count). However, for the B display, the
value is displayed or hidden depending on the value of the parameter (#1170 M2name
2nd miscellaneous code).
For the T display, only the tool number is displayed regardless of the value of the param-
eter "#11038 T disp type".
305
Details
Details
IB-1501453-C