Mitsubishi Electric C80 Series Instruction Manual page 217

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Menus
Menus
This displays the data of a group when that group No. of tool life management data is set and the [IN-
Group
PUT] key is pressed. (*1)
No.
The group No. can be referred to in the group list.
Copies one line of tool life management data where the cursor is located.
Line
copy
The copied tool life management data is written to the data in the line where the cursor is located.
Line
If the copied data is changed after the menu [Line copy] is pressed, the data before changing is written
paste
when pasted.
The copied data can be pasted as many times as is required until new data is copied.
This erases a designated line (multiple lines possible) of tool life management data.
Line
The first and the last line No. of the data to be erased is specified with a "/" separating the Nos..
clear
If the [INPUT] key is pressed without specifying a line, the data in the line where the cursor is located is
erased.
This changes a group No. (*1)
Grp No.
If a new group No. is set and the [INPUT] key pressed, the group No. changes.
change
An error occurs if an existing group No. is specified.
Displays the pop-up window for details of the selected group.
Disp
details
Displays the previous group No. data. (*1)
Prev
group
Displays the next group No. data. (*1)
Next
group
This displays the list of tool life data groups. (*1)
Group
list
This creates a new group. (*2)
Group
regist
This erases all tool life management data contained in the currently displayed group No. (*2)
Group
delete
This closes the pop-up window for details of the selected group.
Close
(*1) This menu is not valid for the tool life management III.
(*2) This menu is not displayed for the tool life management III.
Operation method (Designating a group No.)
(1) Press the menu [Group No.].
(2) Designate the group No. to be displayed.
12 [INPUT]
Note
(1) If a group No. that does not exist is designated, a message appears to confirm the creation of a new No. A new group
is created if [Y] or [INPUT] is pressed.
IB-1501453-C
Details
192