Mitsubishi Electric C80 Series Instruction Manual page 214

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Display items
(5) Method
(6) HNo.
(7) L compen
(a) Tool life management method
(b) Tool radius compensation data format
(c) Tool length compensation data format
(a) Tool life management method
0: Operating time
This manages by the cutting execution time.
1: No. of mounting times
This manages by the No. of times the tool became the spindle tool
in tool replacement, etc. However, in the case where the cutting
feed command (G01, G02, G03 etc.) is not executed even once af-
ter becoming the spindle tool, the No. of times is not counted.
2: T usage count
This is counted when the rapid traverse command (G00 etc.) is
changed to the cutting feed command (G01, G02, G03 etc.). How-
ever, this is invalid in the case of a rapid traverse or cutting feed
command with no movement.
G00 G01 G00 G04 G01
+1 During cutting feed +1
(b) Tool radius compensation data format
(c) Tool length compensation data format
0, 2: Length dimension/Radius dimension
Displays the length dimension or radius dimension of the tool com-
pensation amount of the compensation number designated by
HNo. or Dno. in the display item "L compen" or "R compen".
If the value of the display item "L compen" or "R compen" is
changed, the length dimension or radius dimension of the tool com-
pensation amount is rewritten.
1: Length wear/Radius wear
Displays the length wear or radius wear of the tool compensation
amount designated by HNo. or Dno. in the display item "L compen"
or "R compen".
If the value of the display item "L offset" or "R offset" is changed,
the length wear or radius wear of the tool compensation amount is
rewritten.
Length compensation number.
Entering a new tool number automatically assigns the same compen-
sation number as the tool number.
If a new tool number is entered that is outside the allowable compen-
sation number range, the compensation number is assigned to "0".
The compensation number can also be changed to any number as
needed.
Length compensation value.
One of the following values is displayed depending on the tool length
compensation data format utilized by the method.
The value can be changed as needed.
0, 2: Length dimension of tool compensation amount of the compen-
sation number designated by HNo.
1: Length wear of tool compensation amount of the compensation
number designated by HNo.
Details
G04 G01 G00
189
Setting range
1 to 999
(*3)
IB-1501453-C