Special Program Editing Display For Synchronization Between Part Systems - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
3 Inputting a Machining Program and Defining Variables

3.8.2 Special Program Editing Display for Synchronization between Part Systems

Edit
Edit
Pressing the menu [Synchro view] enables synchronized display of the left- and right-side programs aligned when the fol-
lowing conditions are satisfied:
The parameter "#1285 ext21/bit0" (Multi-part system program management) is set to "1" (valid).
Multi-program display type is selected.
The left and right edit areas are displaying the same named programs of different part systems stored on the NC memory.
Note
(1) The synchronous display is also available for MTB macro program and MDI.
(2) Editing can be performed in the selected editing area, and the synchronous display is disabled when "Editing" is being
displayed. The synchronous display becomes enabled again when the edited contents are determined.
(3) Blank lines, which are inserted automatically to align the left- and right-side programs for the synchronization position,
cannot be pasted with the menu [Paste] operation when the blank lines are specified as the copying range with the menu
[Copy] operation.
(4) The editable machining program size is up to 240 KB per part system.
When the menu [Synchro view] is pressed in the state where a machining program exceeding 240 KB is opened, the
"Can't edit because of size over" message is displayed and the synchronous display cannot be performed.
When a file exceeding 240 KB is opened with "Synchro view" highlighted, the "Can't edit because of size over" opera-
tion message is displayed and the machining program cannot be opened.
(5) The state where the "Synchro view" is highlight is held until the power is turned OFF and ON, a machining program for
which the synchronous display is not available is opened, or the display type is changed to other than "Multi-program
display type".
[Display during synchronous view]
Blank lines are inserted
to align the left- and
right-side
synchronization position.
Cursor line is not
highlighted.
Press
the [Synchro view]
menu
87
The line is displayed with
the line No. includes blank
lines.
The line with the timing
synchronization symbols is
highlighted (with green color).
The line with the timing
synchronization symbol which
does not have the
synchronizing target is not
highlighted.
IB-1501453-C