Mitsubishi Electric C80 Series Instruction Manual page 153

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Display items
Display items
(1) Manual measurement
status display
(2) Reference surface
height
(3) Counter display
L meas: (Axis name)
R meas: (Axis name)
(4) Guide graphic
(5) Tool compensation data Displays the tool compensation data. The contents of the tool compensation data to
(*1) The TLM value counter differs according to the parameter "#1328 TLM type" value.
0: The position when the measurement switch was turned ON is displayed as 0.
1: The display is based on the machine zero point.
Note
(1) If the parameter "#11017 T-ofs set at run" is set to "1", the tool compensation amount data can be measured in the au-
tomatic operation mode or operation pause mode.
IB-1501453-C
This displays the manual measurement status.
Refer to "Manual measurement status display" described later in this section.
This displays a value for the reference surface height.
Setting range: -99999.999 to 99999.999 (mm)
TLM value: This displays the value during measurement. (*1)
This will be the same as the machine position until the sensor is contacted.
This will be the skip coordinate position after the sensor is contacted.
Measurement value:
For tool length measurement type I: TLM value - Reference surface height
For tool length measurement type II: TLM value - Reference surface height + TLM ref-
erence length
For tool radius measurement, measurement result is displayed in absolute value.
The axis selected in the parameters "#8711 TLM L meas axis" and "#8712 TLM D
meas axis" is the target axis for the measurement.
Displays the measurement image. The contents of the guide drawing will differ de-
pending on the tool length measurement ( I or II).
Tool length measurement I guide drawing Tool length measurement II guide drawing
be displayed vary depending on the tool compensation type (I, II, or III).
When tool compensation type III is selected, the display is the same as for tool com-
pensation type II.
Cursor movement, data input and part system changing operation are same as tool
compensation types I and II.
128
Details