Mitsubishi Electric C80 Series Instruction Manual page 92

C80 Series Instruction Manual
3 Inputting a Machining Program and Defining Variables
Operation method (Deleting one line)
(1) Move the cursor to the line to be erased.
(2) Press the [C.B] key.
(3) Press the [INPUT] key.
Note
(1) In the case where the block for the deleted line covers multiple lines, these lines are also deleted.
(2) Last line only with "%" cannot be deleted.
(3) "Executing" is displayed during line clear. The message flashes every second.
Operation method (Deleting designated lines)
(1) Press the menu [Line clear].
(2) Designate the deletion range.
(Example) From line 8 to line 10
8/10 [INPUT]
When deleting 1 line, it is also possible to make a se-
lection using the [↑], [↓] keys and designate by press-
ing the [INPUT] key.
(3) Press the [Y] or [INPUT] key.
Press the [N] key not to delete.
Note
(1) If the [INPUT] key is pressed without setting a line No., the line where the cursor is will be deleted.
(2) If the last line of the file is the range to be deleted, the last line can be designated as "E".
(Example) From 8th line to last line: 8/E
From 1st line to last line: /E
(3) "Executing" is displayed in flickering during line clear.
Operation method (Deleting several lines (one screen of data) displayed on a screen)
(1) Press the [CAN] key.
(2) Press the [INPUT] key.
1 line is deleted at the cursor position, and "Editing" ap-
pears. The lines following the cursor position are shifted
upward. The cursor position does not change.
When this key is held down, the line can be deleted one
at a time.
The edited machining program is saved to the device
and "Editing" disappears.
The background color for the range to be deleted turns
light blue.
The editing data (machining program) for one screen is
deleted and "Editing" appears.
The edited machining program is saved to the device
and "Editing" disappears.
67 IB-1501453-C