Mitsubishi Electric C80 Series Instruction Manual page 171

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Display items
Display items
(1) Display area
<Standard setting/display range >
The display range is when the minimum command unit is 1μm ("#1003 iunit"= B, "#1041 Initial inch" = 0).
Type Setting item
I Compensation
data
II Length
L wear
Radius
R wear
III Wear data
Tool length data Sets the tool length data compensation amount of 1st ax-
Nose R (*3) (*6) Sets the tool radius (Nose R).
R-wear (*3) (*6) Sets the tool radius (Nose R) wear.
Point (*4)
(*1) Select the additional axis by specifying the parameter (#1281 ext17 bit1/#1520 Tchg34).
(*2) If the number of axes in the part system is 2 or less, the name of non-existing axis is displayed according to the param-
eter setting as follows. Setting the compensation amount to non-existing axis does not mean anything.
If "#1281 (PR) ext17/bit1" (Tool offset additional axis selection) is set to "0":
The axis name is not displayed.
If "#1281 (PR) ext17/bit1" (Tool offset additional axis selection) is set to "1":
If the 2nd axis does not exist, the axis name designated by "#1028 base_K" is displayed. If the additional axis does
not exist, the axis name designated by "#1027 base_J" is displayed.
(*3) If the parameter "#1019 dia" (Diameter command) is set to "0", set the radius. If it is set to "1", set the diameter.
(*4) The nose point is entered as the absolute value even if you press the menu [+ Input].
(*5) It may differ from the above display/setting range due to the "#8010 ABS. MAX." and "#8011 INC. MAX." parameter
settings.
(*6) It may differ from the above display/setting range due to the "#8010 ABS. MAX." parameter settings.
IB-1501453-C
Displays the tool compensation data. The cursor is displayed, and you can set the data.
The data exceeding the display area can be displayed by the following keys.
: Scroll one line at a time.
: Switches the display contents for each number of compensation data sets.
Compensation number: This is a compensation data number.
The other display items change according to the tool compensation type.
Refer to the following table for details.
Details
Sets the tool length compensation amount. (*5)
Sets the tool length compensation amount. (*5)
Set the compensation amount of tool length wear. (*5)
Sets the tool radius compensation amount. (*5)
Set the tool radius wear compensation amount. (*5)
Sets the nose wear compensation of 1st axis, 2nd axis,
and additional axes. (*1) (*2) (*5)
is, 2nd axis and additional axes. (*1) (*2)
Sets the nose point (number).
146
Details
Setting/display range
-9999.999 to 9999.999
Length dimension/Radius di-
mension
-9999.999 to 9999.999
Length wear/Radius wear
-9999.999 to 9999.999
-9999.999 to 9999.999
-9999.999 to 9999.999
-9999.999 to 9999.999
-9999.999 to 9999.999
0 to 9