Mitsubishi Electric C80 Series Instruction Manual page 155

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Note
(1) The measurement values are not written if the cursor is in a position other than "Length" or "Radius".
(2) The axis returns and stops after contacting the sensor, but be careful not to move the axis after that. If the axis moves
after contacting the sensor, the distance that was actually moved will be added to the measurement values counter, and
the skip position will not be held.
Manual measurement status display
The display will change as shown below during manual measurement.
Display
On mea 1 This state is entered if a skip signal is input during manual measurement.
The "On mea 2" state is shifted to after deceleration stop is confirmed.
On mea 2 This is the state during the first retract operation.
The "On mea 3" state is shifted to after retracting the retract amount.
On mea 3 This is the state in which retract by the retract amount has completed.
If the skip after deceleration stop confirmation signal is ON, the status display will remain the
same.
The "On mea 0" state is shifted to when this state is reset.
On mea 4 This is the state during the second measurement.
If the skip signal is not input even after moving to the specified position, a warning will appear,
and the status display will remain the same.
The "On mea 0" state is shifted to when this state is reset.
On mea 5 This state is entered when the skip signal is input during the second measurement.
The "On mea 6" state is shifted to after deceleration stop is confirmed.
On mea 6 This is the state during the second return operation.
The "On mea 0" state is shifted to after retracting the retract amount.
On mea 0 This state is entered when not in the "On mea 1" to "On mea 6" states.
Carrying out tool radius measurement
The operating procedure of the tool radius measurement and submenu details are the same as when measuring tool length.
(Use [T-rad. measure] instead of [T-leng measure].)
IB-1501453-C
Meaning
130