Setting The Tool Compensation Data - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece

5.4.1 Setting the Tool Compensation Data

Operation method (Setting "10.000" in the length wear data of compensation No. (102))
(1) Press the menu [Ofs No search].
(2) Designate the Compensation No.
102 [INPUT]
The cursor can be moved to 102 using the [↑], [↓],
, or keys.
(3) Use the [→] key to move the cursor to the length
wear position.
(4) Input the length wear value.
10 [INPUT]
The value can also be designated by pressing the
menu [=INPUT] instead of the [INPUT] key.
Note
(1) If the parameter "#11017 T-ofs set at run" is set to "1", the tool compensation amount data during automatic operation
or during pause of operation can be set.
(2) When the parameter "#8929 Disable=INPUT:comp" is set to "1", [=Input] menu will be grayed.
(3) This setting will be disabled due to the parameter "#8933 Disable lngth comp" or "#8934 Disable wear comp" setting.
For details, refer to "5.4.6 Disabling the Setting of Tool Compensation Amount".
(4) The above shows the setting of the tool compensation data when the parameter "#8941 ABS/INC for T-ofs" is set to "0".
For details, refer to "5.4.2 Switching the Input Method for the Tool Compensation Data".
(5) When [=Input], [+Input] and [Input] are pressed and when the parameter "#1124 ofsfix" is set to "0", the cursor will move
to the next compensation No.
149 IB-1501453-C