Mitsubishi Electric C80 Series Instruction Manual page 117

C80 Series Instruction Manual
3 Inputting a Machining Program and Defining Variables
Operation method (Erasing the variable name for variable No. 509)
(1) Press the menu [Name clear].
(2) Select the variable , and press the [INPUT] key.
509 [INPUT]
(3) Press the [Y] key.
Note
(1) The variable at the cursor position will become the target of the erasing if the [INPUT] key is pressed without designating
a variable No.
(2) The variables in the range below are the erasing target when /E is designated.
Input example
100/E
500/E
Switching the variable No.
Methods to switch the display areas are as follows.
(1) Use the menu [Var No search].
(2) Use the page up/down keys.
If you press the next page key during displaying the last page of the area, the first page of the next area will be dis-
played.
If you press the previous page key during displaying the first page of the area, the last page of the previous area will
be displayed.
(Example) If you press the next page key during displaying the last page of the common variable 2 (for each part sys-
tem) (#100 -), the first page of the common variable 1 (common to part systems) (#500 -) will be displayed.
(3) Use a cursor key
When a cursor key is placed at the biggest variable No. in the area, the first page in the next area will be displayed by
pressing [↓] or [→|].
When a cursor key is placed at the first variable No. in the area, the biggest variable No. in the previous area will be
displayed at the top by pressing [↑] or [|←].
(4) Use a scroll bar
The first page of the next area will be displayed by pressing ▼, while the last page of the area is displayed.
The biggest variable No. in the previous area is displayed at the head by pressing ▲, while the first page is displayed.
Variable numbers cannot be displayed continuously if another display area is inserted in between.
IB-1501453-C
Erasing range
100 to 199
500 to 599
The variable name for 509 only is erased.
The variable value is not erased.
Supplement
Only variable name in the displayed part system is
cleared.
92