Mitsubishi Electric C80 Series Instruction Manual page 210

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Menus (M system/L system)
Menus
Creates a new group and adds the group No. to the list.
Group
regist
This erases all of the tool life management data included in the designated group No.
Group
If the group No. is not designated, the tool life management data for the group No. indicated by the cur-
delete
sor will be erased.
This erases all groups and their tool life management data registered in the part system which is cur-
Grp all
rently selected.
delete
This changes a group No.
Grp No.
Specify a new group No. and press the [INPUT] key to change the group No. and then change the con-
change
tents of the list.
An error occurs if an existing group No. is specified.
The tool life data for the group No. indicated by the cursor is displayed.
T-life
This changes to the mode enabling tool life management data to be set and displayed with group unit
group
Nos.
Operation method (Registering a group) (M system/L system)
(1) Press the menu [Group regist].
(2) For L system, set group No./method/life value.
(Example) 25/1/3000 [INPUT]
For M system, designate the group No. to be registered.
25 [INPUT]
Note
(1) An error occurs if the group No. duplicates a pre-existing group No.
(2) The group is not registered if one of the operations below is performed after registering a new group No.
If the application is exited without registering even 1 item of tool life data.
The screen is changed to that of other than the group unit display.
The part system is changed.
Operation method (Erasing a group) (M system/L system)
(1) Press the menu [Group delete].
(2) Designate the group to be erased.
72 [INPUT]
If nothing is input in the input area, the group at the cursor location is erased.
Details
The selected group No. is erased.
185 IB-1501453-C