Mitsubishi Electric C80 Series Instruction Manual page 94

C80 Series Instruction Manual
3 Inputting a Machining Program and Defining Variables
Note
(1) The marking status is maintained when another program is opened while character strings are still marked.
(2) If the input mistake check warning function is enabled while character strings are still marked, the marking is given pri-
ority in the case where the input mistake location and the marked display overlap.
(3) In the case where the search marking and input mistake check warning function are displayed simultaneously, the mark-
ing is cleared and the input mistake warning display remains.
(4) With the multi-program display type, the search and marking is valid only in the area where the search and marking is
carried out.
(5) With the multi-program display type, the character string and color to be marked are not synchronized in the each editing
area.
(6) The marked status is maintained until the NC power is turned OFF.
Important points when performing search
(1) If the designated character string cannot be found, the operation message "Designated character string not found" ap-
pears.
(2) A search is performed for a character string containing the designated character string, irrespective of the characters
before and after. As a result, if "G2" is designated, G20 - G29 and G200 etc. will also be the subject of a search.
Character string data setting example
Designated character string
N10
N10 X100.
X-012.34
Search character string example
Character strings that include "N10" such as "N10" and "N100".
Character string "N10 X100."
Character string "X-012.34" (A search is not performed for "X-12.34".)
69 IB-1501453-C