Copying And Pasting The Tool Compensation Data; Undoing Change Of Tool Compensation Data - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece

5.4.4 Copying and Pasting the Tool Compensation Data

Operation method (Copying/pasting one line of tool compensation data)
(1) Move the cursor to the data to be copied using the [↑],
[↓], or key.
(2) Press the menu [Line copy].
(3) Move the cursor to the line (compensation No.: 109)
where the data is to be pasted.
(4) Press the menu [Line paste].
Note
(1) If the compensation data for the copied line is changed after the menu [Line copy] is pressed, the data prior to the change
is written when pasted.
(2) In tool compensation type lll, the copied data cannot be pasted to the different item (Wear/Length/Nose).
(3) If the parameter "#11017 T-ofs set at run" is set to "1", the tool compensation amount data during automatic operation
or during pause of operation can be erased.
(4) This setting may be disabled due to the parameter "#8933 Disable lngth comp" or "8934 Disable wear comp" setting.
For details, refer to "5.4.6 Disabling the Setting of Tool Compensation Amount".

5.4.5 Undoing Change of Tool Compensation Data

(1) Move the cursor to the data to be set using the [↑], [↓],
, or key.
(2) Input a numeric value.
(Example) 10 [INPUT]
(3) Press the menu [Undo].
Note
(1) This setting will be disabled due to the parameter "#8933 Disable lngth comp" or "#8934 Disable wear comp" setting.
For details, refer to "5.4.6 Disabling the Setting of Tool Compensation Amount".
(2) When "#8939 Undo confirm msg" is set to "1", the menu [Undo] is highlighted and confirmation message "OK? (Y/N)"
is displayed. The program returns to the previous status by pressing [Y] or [INPUT] key. If any key other than [Y] or
[INPUT] is pressed, the operation to undo will be canceled. When the operation is canceled, the menu highlight returns
to normal and the message disappears.
(3) When the program does not return to the previous status by pressing [Undo], [Undo] is not highlighted and the operation
message "Data protect" or "Cannot return to origin" appears.
(4) The menu [Undo] cannot be used to clear multiple lines.
The copied compensation data is written in the line
where the cursor is.
The background color returns to normal.
The copied compensation data is held until another line
is copied.
The value is returned to the previous value.
153 IB-1501453-C