Mitsubishi Electric 700 Series Training Manual page 117

3. Setup Screen
Display items (M system)
Display item
(1) Group No.
(2) #
(3) Tool No.
(4) ST
This is the group No. of the tool for which tool life management is
performed.
Tools with the same group No. are regarded as spare tools.
This is the data setting No.. This is not the magazine pot No.
This is the No. corresponding to the each individual tool.
Maximum 1000 tools can be registered.
This is a fixed tool No. actually output for the tool command and
so on.
Tool status
Machine manufacturer release
Tool status
0 : Unused tool
Normally set to "0" when the tool is replaced with a new
tool.
1 : Used tool
This becomes "1" when the cutting actually starts.
2 : Normal life tool
This becomes "2" when the usage data (usage time and
No. of uses) exceeds the life data.
3 : Tool abnormality 1 tool
4 : Tool abnormality 2 tool
(Note) Item 3 and 4 differ depending on the machine tool builder
specifications.
109
3.5 Tool Life Management
Details Display range
1 to 99999999
1 to 99999999