6. Maintenance Screens
6.2.3 Transferring a File
Operating method
(1) Press the menu
select file setting column A.
(2) Designate the transfer origin device,
directory and file name.
(3) Press the menu Area change , and
select file setting column B.
(4) Designate the transfer destination device,
directory and file name.
(5) Press the menu Trnsfr A ->B .
(6) Press Y or
CAUTION
" ; ", "EOB", "%", and "EOR" are symbols used for explanation. The actual codes for ISO are "CR,
LF" ("LF") and "%".
The programs created on the Edit screen are stored in the NC memory in a "CR, LF" format,
however, the programs created with external devices such as the FLD or RS-232C may be stored
in an "LF" format.
The actual codes for EIA are "EOB (End of Block)" and "EOR (End of Record)".
!
To prevent the influence of data loss and data transformation over the line, always carry out data
comparison after transferring a machining program.
Area change , and
INPUT .
The designated file appears.
A message appears to confirm the transfer.
G91 G28 XYZ;
INP data :
F1000;
CMP data :
250
6.2 Input/Output Screen