Transferring The Data To Got (Using An Usb Cable); Installing Os On Got - Mitsubishi Electric C70 Setup Manual

MITSUBISHI CNC
2 GOT Initial Setup

2.1.5 Transferring the Data to GOT (Using an USB cable)

Install OS on GOT and then transfer the project data, where required settings have been made, to GOT.
This section explains the procedure when using an USB cable.
When using a CF card, refer to "Transferring the Data to GOT (Using a CF card)".
GT Designer3

2.1.5.1 Installing OS on GOT

OS, including standard monitor OS and communication driver, is necessary to make GOT operate. Make sure to install
them before downloading the created project data.
See below for the details of each data. For details, refer to the "GT Designer3 Version1 Screen Design Manual
(Fundamentals)" (SH(NA)-080866), Section 8.
Data type
The software required to control the GOT hardware and
BootOS make a communication between the PC and GOT. (Note)
Factory-installed. Reinstallation is not generally required.
The software for operating the monitor function, touch key
OS(Standard
control, system screen and guidance display function and
monitor OS)
other features.
User screen data, common settings, comment, High Quality
Project data
font, True Type font, etc.
(1) Turn ON the GOT, start GT Designer3 on the personal computer, and select [Communication]-[Communication
Configuration...] from the menu bar.
(Note) At starting GT Designer3, if the "New Project Wizard" dialog box appears, close the dialog box.
22
USB
GT09-C20USB-5P
GT09-C30USB-5P
Outline
GOT1000 Series
(SVGA / XGA)
Storage destination (Drive in GOT)
C: Built-in Flash Memory
A: Standard CF Card or C: Built-in
Flash Memory
A: Standard CF Card or C: Built-in
Flash Memory