MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#6451】
bit3: Key data via PLC
Validates the key data in the shared device G10212, which is set by the sequence programs.
If this parameter is valid, the key data, read out from the shared device on NC (G10208), must be
returned to the shared device on PLC (G10212) even if the data will not be changed by sequence
programs.
Unless the data is returned to PLC, keys are not available.
When the programs stop on PLC (including when STOP is selected with the RUN/STOP switch), key
data is not accessed via PLC.
0 : Invalid
1 : Valid
【#6454】
bit0: Macro interface for respective part systems
Designate whether to use the macro interface for respective part systems or not.
0 : Conventional macro interface common to part systems.
1 : Available to respective part systems.
370