Mitsubishi Electric C70 Setup Manual page 404

【#7584】 <check> Selection of area check method PSW9
When position switch area checking at high speed is selected, specify the mode of area checking,
i.e., whether to use the command type machine position or detector feedback position, for each
position switch point.
0: Use the command type machine position as the machine position for position switch area
1: Use the detector feedback position as the machine position for position switch area checking.
【#7591】 <axis> Axis name PSW10
Specify the name of the axis for which a position switch is provided.
---Setting range---
NC axis: axis name (X, Y, Z, U, V, W, A, B, or C)
PLC axis: PLC No. (1 to 8)
【#7592】 <dog1> Imaginary dog position 1 PSW10
When the machine enters the range between imaginary dog positions 1 and 2, a signal is output to
the PLC.
Part system 1 device: X669
Part system 2 device: X6E9
---Setting range---
-99999.999 to 99999.999 (0.001mm)
【#7593】 <dog2> Imaginary dog position 2 PSW10
When the machine enters the range between imaginary dog positions 1 and 2, a signal is output to
the PLC.
Part system 1 device: X669
Part system 2 device: X6E9
---Setting range---
-99999.999 to 99999.999 (0.001mm)
【#7594】 <check> Selection of area check method PSW10
When position switch area checking at high speed is selected, specify the mode of area checking,
i.e., whether to use the command type machine position or detector feedback position, for each
position switch point.
0: Use the command type machine position as the machine position for position switch area
1: Use the detector feedback position as the machine position for position switch area checking.
【#7601】 <axis> Axis name PSW11
Specify the name of the axis for which a position switch is provided.
---Setting range---
NC axis: axis name (X, Y, Z, U, V, W, A, B, or C)
PLC axis: PLC No. (1 to 8)
【#7602】 <dog1> Imaginary dog position 1 PSW11
When the machine enters the range between imaginary dog positions 1 and 2, a signal is output to
the PLC.
Part system 1 device: X66A
Part system 2 device: X6EA
---Setting range---
-99999.999 to 99999.999 (0.001mm)
checking.
checking.
C70 Setup Manual
Appendix 1.13 Position Switches
387